CMS Bond 100 High Performance Acoustic Sealant

CMS Bond 100 is a solvent free, low VOC, high performance water based acrylic dispersion with very good bond strength. It is suitable for plasticized vinyl floor coverings (including PVC tiles) together with high density foam backed carpets and for products such as Regupol 3912 Acoustic Underlayment, Regupol 4515 Multi Acoustic Underlay, Regupol 4515 Eco soundproof underlay and Karma products. CMS Bond 100 is a ready to use versatile product and does not have to be diluted or adulterated in any way.

• Concrete,
• Flooring grade hardboard,
• Plywood,
• Chipboard,
• Sand/cement screed,
• Self-smoothing underlayments.
  

• CMS Bond 100 is a ready to use versatile product and should not be diluted or adulterated in any way
• Site conditions should comply with the latest British Standards editions: BS 8102 (Code of Practice for protection against moisture from the ground), BS 8203 (Code of Practice for installation of resilient floor coverings), BS 5325 (Code of Practice for installation of textile floor coverings), BS 8204 part 1 (Code of Practice for installation of self levelling screeding compounds), and supplementary specifications.,
• Surfaces must be level, firm and clean, free of loose material, mould, oil, grease, organic growth and surface moisture (under 75% RH).
• Uneven, dusty or friable surfaces should be treated with the appropriate universal primer and screed.
• It is essential that suitable damp proof membranes be in place to prevent rising damp.
• Under floor heating should be turned off for at least 48 hours prior to and after application.
• Particular attention must be paid to the floor covering manufacturer’s instructions. i.e. any pre storage conditions prior to fitting.
• Use a notched trowel of dimensions 1.5mm x 5mm or as CFA guidelines.
  
• Heavy textured floor coverings may require a larger towel.
• Apply adhesive evenly to the substrate and depending on the substrates lay the floor covering while still wet. It is best to allow the freshly applied adhesive to stand for 15-45 minutes depending on the ambient conditions, to build tack before embedding the floor covering.
• Press firmly into place and rill using a 60/70Kg roller or glider depending on material used. Roll again approximately 1 hour after application.
• Wait at least 24 hours before welding vinyl seams.