The WEC 732 profile has an increased drip section to improve visual appearance and a large front face to help prevent water blowing up and soaking the insulation. The new design of drip also allows the end caps to be riveted into position. Manufactured from 1.2mm pre-coated white aluminium, in lengt..

160mm Aluminium System Starter Track Profile for Curved Walls for 120mm insulation. Slit the back fixing leg and then bend profile around the curve of the wall...

Aluminium Facade Corner Profile Without Covered Cutting Edges - Profile 9484 length of 3m. Corner profiles cover the cutting edges of the facade boards and form a clean, precise edge. Vertical corner profiles must be fastened at one fixed point at the top. If conditions require multiple fasteni..

The WEC 732 profile has an increased drip section to improve visual appearance and a large front face to help prevent water blowing up and soaking the insulation. The new design of drip also allows the end caps to be riveted into position. Manufactured from 1.2mm pre-coated white aluminium, in lengt..

80mm WEC End Cap for Verge Trim Profiles can be used with; WEC 771, WEC 781, WEC 791 AND IGT range of profiles. Manufactured in 1.2mm pre-coated white aluminium...

The WEC 781 Grind in Verge Trim Profile is designed for use in situations where there are problems sealing the rear of the profile. It is also a cost effective way to seal the system instead of increasing the roof line. This profile also has an increased drip section to improve visual appe..