Aluminium Facade Corner Profile Without Covered Cutting Edges - Profile 9441 Anodised Finish - length of 3m

Aluminium Facade Corner Profile Without Covered Cutting Edges - Profile 9441 Anodised Finish length of 3m. Corner profiles cover the cutting edges of the facade boards and form a clean, precise edge. Vertical corner profiles must be fastened at one fixed point at the top. If conditions require multiple fastening points on a profile, the other fastenings must be sliding points. Profiles must always be mounted without pressure or stress to allow for expansion. The installation temperature must be taken into consideration and maintain the necessary distances at profile joints. Like most components of rear-ventilated curtain walls, the facade profiles must not be constrained. Always allow for linear expansion in the profiles. 

Note: Colour code EV1 - this profile is anodised and not coated to a certain RAL colour

INSTALLATION

• The vertical corner profile should correspond with a joint of the facade cladding.
• Corner profiles can also be offset with the joint of the facade cladding, where applicable..
• Joint tapes can prevent water from penetrating.
• Always allow for linear expansion in the profiles.