1.6mm Plasticlad Stainless Steel Spacer Washer is a premium component designed for use with PTS fixings in rainscreen cladding systems. These washers are specifically designed to create a defined gap between the cladding panel and the supporting subframe (whether timber or metal).CHARACTERISTICSManu..

PlastiClad Aluminium Edge Trim AL/715 for Single Panels is a high-precision architectural profile designed to provide a neat, protective termination for individual cladding sheets. This trim is engineered specifically to house the edge of a single, flat panel (such as a large-format composite s..

100mm Plastestrip FastFrame Aluminium Double Helping Hand Bracket - FF FIX/BRD/100 is the primary load-bearing component within the Plastestrip sub-frame system. While the single bracket is typically used for intermediate wind-load support, the double bracket is engineered to act as the Fixed P..

PlastiClad Aluminium Vent Trim to Close 50-70mm Cavity AL/VENT/50/70 is a precision-punched architectural trim designed to maintain a continuous air path behind cladding panels while simultaneously acting as a physical barrier against pests. These profiles are typically installed at the base of..

50mm Plastestrip Colour Coated Annular Ring Shank Nails for fixing panels to timber. A4 stainless steel (316 grade). Can be powder coated to any colour...

Undercut Anchor for 7mm Embedment is a specialised mechanical fixing designed for the high-end "secret fix" installation of thin cladding panels, typically High-Pressure Laminate (HPL), ceramic, or natural stone. The undercut anchor relies on a precise "undercut" geometry drilled into the rear of th..